VISION PLASTIC EMULSION
VISION PLASTIC EMULSION a PVA co-polymer based interior decorative paint. It has excellent brushabilityand provides a smooth, flat finish. It can be used on surfaces like concrete, plaster, and masonry. It hasgood hiding power and adhesion with a primer. It dries to touch in 1 hour and can be recoatedwithin2-4hours. It is economical and has anti-fungal and anti-bacterial properties.
RECOMMENDED USE.
Recommended for exterior / interior use on plaster, concrete, gypsum, brickwork and asbestos surfacewhere long lasting and washable finished is required.
| Paint type | Product type | Finishing | Recommended Substrate | Pack Size |
|---|---|---|---|---|
| Water based | Interior | Smooth / Matt | Plaster, brick & masonry | 1 litter, 3.64 liter & 14.56 litterComposition |
Composition
- Pigment
- Binder
- Thinner
Application method
- Spray – Use airless spray
- Brush – Recommended
- Roller – Recommended
Technical Data
- Volume Solid: White 43% (nominal) , other colours will vary
- Film Thickness: Wet: 60 – 70 µm
Dry : 25- 30 µm - Drying Time: Touch Dry: Single coat at stander film thickness Dependent on
temperature and humidity - Recoating Time: 2 – 3 hours (Dependent on temperature and humidity).
- No. of Coats: of Coats: 2 – 3 coats
- Theoretical Coverage: 19 – 11 m2 per litter per coat (Actual coverage is dependent onsubstratecondition, application method, application condition and finishing appearance).
- Shelf Life: Up to 24 months in tight sealed container
- Shades: available as per demand.
Note
Theoretical Coverage is based on a mathematical formula and does not consider Loss Factor
[ Volume Solid % × 10 / Dry Film Thickness (µ) ] = m² /lit/coat
This theoretical coverage rate has been calculated from the volume solids of the material andisrelated to the amount of coating applied onto a perfectly smooth surface without wastage. Forapractical coverage rate, due allowance should be made for atmospheric conditions, surfaceroughness, geometry of the article being coated, the skill of applicator, method of applicationetc.when estimating quantities required for a particular job. The above information is giventothebestof our knowledge