QUICK DRYING ENAMEL
A quick drying enamel based on a special modified alkyd. It gives a tough, flexible and high gloss finish with excellent leveling. The dried film withstands abrasion, scratch and impact resistances. It can be applied by dip application also.
• Protective coating for structural steel, pipes, scaffolding, drums, vehicles, industrial and agricultural machineries. Most suitable for production line jobs for fast production. It is suitable for interior/exterior surfaces as a part of alkyd systems.
| Shades | AS per shade card |
| Finish Dry film | glossy |
| Specific Gravity | 1.10 ± 0.05 |
| Volume Solids (ASTM D2697) | 50 ± 2% |
| Theoretical Spreading rate (TSR) | 12 – 10 m² / liter |
| Dry film thickness (DFT) | 30 – 40 microns / coat |
| Wet film thickness (WFT) | 60 – 80 microns / coat |
| Flash Point | 30°C |
• Quick drying enamel, gives tough, flexible and high gloss finish with excellent leveling.
Dried film has good abrasion, scratch and impact resistances, suitable for dipping applicatio
• Certificates are available upon request
| 1 liters | 3.64 liters | 14.56 liters |
| TOUCH DRY | 5 – 10 minutes |
| DRY TO RECOAT | 4 – 6 hours |
| FULLY CURED | 10 – 12 hours |
Surface should be clean, dry and free from any contamination. Oil and grease should be removed
by solvent cleaning as per SSPC SP-1. Abrasive blast cleaning to Sa 2.5
| Working pot Life@30°C | 1 hours (reduced at higher temperatures) |
| Thinner | Vision Epoxy thinner |
| Airless spray | Tip Range: 0.018” – 0.020” Pressure: 2200 psi Thinner addition: 5–10% |
| Conventional spray | Atomizing pressure: 40 psi Thinner addition: 10–15% |
| Brush, Roller | Thinner addition: 5–10% |
- Avoid skin and eye contact by wearing overalls, gloves, goggles, and mask etc.
- Eyes: In the event of accidental splashes, flush eye with water immediately and obtain medical advice.
- Skin: Wash skin thoroughly with soap and water or approved industrial cleaner.
- Avoid inhalation of vapours and paint mist by wearing suitable mask. In the event of ingestion seek medical attention immediately.
- This product is flammable, keep away from sources of ignition. Take precautionary measures against static discharge. In the case of fire – blanket flames with foam, carbon dioxide or dry chemicals.
- Painting must be carried out in well-ventilated area. Local safety regulations need to be followed.
| Vision QD Primer | 60 microns |
| Vision Undercoat | 60 microns |
| Vision top coat | 50 microns |
• Please consult Vision Technical team for other system recommendation.
- Store the paint in proper storage conditions as per the local regulations. Keep the paint container in sealed condition under shed, away from direct sunlight and extreme temperatures.
- Do not keep paint material near to any ignition sources.
- Do not put back the half or unused material back in original container, containing the supplied paint, to avoid contamination.
- Handle with care.
- Stir well before use.
- Shelf life at 30°C is 18 months in original sealed container, with proper storage conditions.